The ports are on the opposite side to the power connector There are two LEDs per port (one indicates speed/activity, the other shows POE status) The power cord measures approximately 117” long, including the inline power brick that is approximately 55” from each end of the cord. Although the switch is not intended to run in environments below 0☌, it has performed well in my garage – I have it mounted against the inside wall so temperatures generally stay at or above -10☌ throughout the winter. I ordered this switch for my garage to support four wired POE security cameras (mounted on the garage soffits). I’ve had very good luck with TP-Link networking equipment (routers, switches and smart plugs/switches) so I preference them when buying new network equipment. This is a well-performing 4-port POE + 1-port non-POE gigabit switch. With desktop design, outstanding performance and quality, the TP-Link''s TL-SG1005P 5-Port Gigabit Desktop Switch with 4-Port PoE is an ideal choice for expanding your home or office network. It requires no configuration and installation. If there is an additional PD inserted to Port 3 with 10W, and then the system will cut off the power of Port 4 because of the overloaded power, this means Port 1, 2 will use 15.4W, and Port3 will use 10W, no power will be supplied to Port 4.Easy To Use TL-SG1005P is easy to install and use. For an example, Port 1, 2 and 4 is using 15.4W (maximum power for per port is 15.4W) the system power is 46.2W in total. If all PoE PDs power consumption is >= 56W, a priority will be arranged among the PoE ports, then the system will cut off the power of the lowest-priority port.Port Priority Function Priority (Port 1=Port 2=Port 3>Port 4): This function will help to ensure the normal operation of the system, it means Port 4 will be cut off when all total PoE PDs power consumption exceed 56W. These PoE ports can automatically detect and supply power with those IEEE 802.3af compliant Powered Devices (PDs).Overload Arrangement TL-SG1005P has the priority function which will help protect the system when the system power is overloaded. ![]() Power over Ethernet 4 of the 5 Auto-Negotiation RJ45 ports (Port 1 to Port 4) of the switch support Power over Ethernet (PoE) function. In this situation, the electrical power is transmitted along with data in one single cable allowing you to expand your network to where there are no power lines or outlets, where you wish to fix devices such as APs, IP Cameras or IP Phones, etc. ![]() It can automatically detect and supply power with all IEEE 802.3af compliant Powered Devices (PDs). What This Product Does TL-SG1005P is a 5 10/100/1000Mbps ports unmanaged switch that requires no configuration and provides 4 PoE (Power over Ethernet) ports.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |